Honda GoldWing 1500 Dual headlights:
4-pin Harness plug-in, Compact design
For Stock MAX 45W each, or LED bulbs
In stock




150GW is designed specifically for the Goldwing 1500 motorcycles. It plugs in-line with 4-pin harness connectors
It's slim enough to fit behind the headlight assembly.

150gw Product

MAX power rating is 100 watts or 50 watts each bulb., which is sufficient for the stock 45W bulbs. DO NOT EXCEED! 

If you have higher wattage bulbs, or you plan to use them in the future, it is advisable to use the P115W-D product to handle the
 extra load.

BOTH headlight bulbs will modulate together as synchronized. Side-to-side (or wig-wag) flashing is reserved for Police or Emergency vehicle use only. 

150GW circuit modulates the hi-beam current - from 100% ON to about 17% OFF. This is accomplished by using a p-channel MOSFET, which is inherently safe; the MOSFET is designed to fail in the ON state. For additional safety, the circuits DO NOT utilize the lo-beam whatsoever! 
Programmable Daylight Sensor
150GW comes with a detachable daylight sensor, which simply plugs into the pathBlazer. The daylight sensor functions as a switch; it stops modulation when it cannot see enough daylight. Since the internal circuitry is controlled by a microprocessor, it allows for customizable features.
3-Click Progarmming: If you turn the high beam on and then turn the ignition on three times quickly, the sequence is interpreted as an active command to change the sensitivity. Software version v.823A allows 8 linear steps between the high and low end. 
150GW Installation 
pathBlazer uses a soft switching technique, which throttles the current flow through the bulb filame
nt, so that there's no "thermal shock" - as opposed to a sudden inrush of current, which can damage the bulb filament or shorten it's life considerably. This is far superior than maintaining a small voltage! 

The daylight sensor has a low frequency filter to avoid false triggering. Please note that florescent lamps may not trigger the sensor - it needs constant incandescent light. 

Select hi-beam to modulate - as long as there's sufficient daylight. If you enter a tunnel or if it gets dark, it will stop the modulation of the hi-beam and stay ON steady. Select lo-beam to end modulation. 
DIY logo
Installation does not require any special tools. Everything needed to complete the job is in the product package.
Follow the steps described here and refer to the Installation Manual enclosed in the product package.
More Information
UPC 013964190007
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account

People Also viewed…