P115W-H3-VK4

valk

Newer Honda Valkyrie headlamps

LED drive software is pre-loaded on this modulator.

In stock
SKU P115W-H3-VK4
$129.95

P115W-H3-VK4

vk4

P115W-H3-VK4 is designed with a 4-pin plug for the factory LED headlamp of the new Valkyrie models. It has matching 4-pin plug and socket for simple plug-in installation. Simply take apart the stock 4-pin connection and plug the pathBlazer in between.

4-pin plug

Shown is the 4-pin plug of the LED headlight. Access to it doesn't require any panel removal.

pathBlazer circuit modulates the hi-beam current - from 100% ON to about 17% OFF. This is accomplished by using a p-channel MOSFET, which is inherently safe. The MOSFET is designed to fail in the ON state. For additional safety, the circuits DO NOT utilize the lo-beam whatsoever!

This unit has a software version specifically for LED drive.

DO NOT use for incandescent bulbs. 

P115W-H3-VK4 comes with a detachable daylight sensor, which simply plugs into the pathBlazer. The daylight sensor functions as a switch; it stops modulation when it cannot see enough daylight. Since the internal circuitry is controlled by a microprocessor, it allows for customizable features.

Programmable Daylight Sensor

VK4-install

3-Click Programming: If you turn the high beam on and then turn the ignition on three times quickly, the sequence is interpreted as an active command to change the sensitivity. Current software version v.3C-11 allows 8 linear steps between the high and low end. 
The daylight sensor has a low frequency filter to avoid false triggering. Please note that florescent lamps may not trigger the sensor - it needs constant incandescent light. 

pathBlazer uses a soft-switching technique. It throttles the current flow through the LED arrays of headlamps, so that appopriate intensities are maintained for modulation. 

Select hi-beam to modulate - as long as there's sufficient daylight. If you enter a tunnel or if it gets dark, it will stop the modulation of the hi-beam and stay ON steady. Select lo-beam to end modulation.

diy

Installation does not require any special tools. Everything needed to complete the job is in the product package.

Follow the steps described here and refer to the Installation Manual enclosed in the product package. 

Installation videos with standard bulbs and LED bulbs are viewable on our YouTube channel. Or you can search for them directly on YouTube.

 

Click here for Installation Manual

More Information
UPC 013964191134
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account

People Also viewed…