P115W-H3-AF2

Africa Twin

Africa Twin models. LED software is pre-loaded.

In stock
SKU P115W-H3-AF2
$129.95

P115W-H3-AF2

AF2

P115W-H3-AF2 is designed with a 2-pin plug for the controller of the factory LED headlamp of the 2015 and newer Honda AFrica Twin models.

As shown here, you can access the 2-pin high beam plug of the LED headlight, located below the left handlebar assembly. Once the left fairing is removed, you can remove the mounting screw of the handlebar. Simply take apart the WHITE 2-pin connection and plug the pathBlazer in between and attach the ground wire.

2-pin plug

pathBlazer circuit modulates the hi-beam current - from 100% ON to about 17% OFF. This is accomplished by using a p-channel MOSFET, which is inherently safe. The MOSFET is designed to fail in the ON state. For additional safety, the circuits DO NOT utilize the lo-beam whatsoever!

This unit has a software version specifically for LED drive.

P115W-H3-AF2 comes with a detachable daylight sensor, which simply plugs into the pathBlazer. The daylight sensor functions as a switch; it stops modulation when it cannot see enough daylight. Since the internal circuitry is controlled by a microprocessor, it allows for customization features.

AF2 install

Programmable Daylight Sensor

3-Click Programming: If you turn the high beam on and then turn the ignition on three times quickly, the sequence is interpreted as an active command to change the sensitivity. Current software version v.3C-11 allows 8 linear steps between the high and low end.

The daylight sensor has a low frequency filter to avoid false triggering. Please note that florescent lamps may not trigger the sensor - it needs constant incandescent light.

pathBlazer uses a soft-switching technique. It throttles the current flow through the LED arrays of headlamps, so that appropriate intensities are maintained for modulation.

Select hi-beam to modulate - as long as there's sufficient daylight. If you enter a tunnel or if it gets dark, it will stop the modulation of the hi-beam and stay ON steady. Select lo-beam to end modulation.

DIY logo

Installation does not require any special tools. Everything needed to complete the job is in the product package.

Follow the steps described here and refer to the Installation Manual enclosed in the product package.

Installation videos with standard bulbs and LED bulbs are viewable on our YouTube channel. Or you can search for them directly on YouTube.

Click here for Installation Manual

More Information
UPC 013964190809
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account