P115W-DHL

Hi-Lo-Headlight

Bikes with (2) headlights

Low-beam stays ON

Choose adapters from below

In stock
SKU P115W-DHL
$169.95

P115W-DHL

P115W-DHL-product
P115W-DHL
 is a Master/Slave configuration. There are no additional boxes to wire-in, or any wires to be cut.  


P115W-DHL designed for a motorcycle with dual H7 2-pin Japanese or EURO style headlamps, or dual HB9/HB11 oval plug headlight bulbs.

For plug-n-play installation, select Bulb Adapter Option from above. The Aadpters will come pre-installed with the unit. 

The Dual High/Low DHL-version requires that the lo-beam bulb stays ON, even when the hi-beam is switched on. DHL-version will modulate both bulbs during daytime.

pathBlazer circuit modulates the hi-beam current - from 100% ON to about 17% OFF. This is accomplished by using a p-channel MOSFET, which is inherently safe. The MOSFET is designed to fail in the ON state. For additional safety, the circuits DO NOT utilize the lo-beam whatsoever!

MAX power rating is 115 watts. DO NOT EXCEED! 

P115W-DHL comes with a detachable daylight sensor, which simply plugs into the pathBlazer. The daylight sensor functions as a switch; it stops modulation when it cannot see enough daylight. Since the internal circuitry is controlled by a microprocessor, it allows for customizable features.


Programmable Daylight Sensor

3-Click Programming: If you turn the high beam on and then turn the ignition on three times quickly, the sequence is interpreted as an active command to change the sensitivity. Software version v.823A allows 8 linear steps between the high and low end.

The Daylight sensor has a low frequency filter to avoid false triggering. Please note that florescent lamps may not trigger the sensor - it needs constant incandescent light. 

P115W-DHL-Install
pathBlazer uses a soft-switching technique. It throttles the current flow through the bulb filament, so that there's no "thermal shock" due to a sudden inrush of current, which can damage the bulb filament or shorten its life considerably. This is far superior than maintaining a small voltage! 

Select hi-beam to modulate - as long as there's sufficient daylight. If you enter a tunnel or if it gets dark, it will stop the modulation of the hi-beam and stay ON steady. Select lo-beam to end modulation.

DIY logo
Installation does not require any special tools. Everything needed to complete the job is in the product package.
 

Follow the steps described here and refer to the Installation Manual enclosed in the product package.

 
More Information
UPC 013964190083
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account

People Also viewed…