Be the first to review this product

Availability: In stock


Quick Overview


BMWs with 6-pin AMP connector for the headlight housing.

Many R-series and K-series models.

* Required Fields



Double click on above image to view full picture

Zoom Out
Zoom In

More Views



F650-plugP115W-A6 is a plug-in version for BMWs with an AMP 6-pin connector of the headlight housing, which is accessible at the back of the housing. This is an EXTERNALLY mounted unit and does not fit inside the headlight assembly. 

P115W-A6 is a plug-in unit for many BMW K-series and R-series models. It modulates hi-beam bulbs - one or two depending on the multiple bulb arrangement of headlights. This is heavy-duty version with dual MOSFETs.

■ For CAN-bus BMWs, choose "Z" version above.

The unit is 1.0"(25.4mm) by 1.35" (34.4mm), and externally mounted. The matching adapter for the AMP connector makes this a plug-n-play operation. 
pathBlazer circuit modulates the hi-beam current - from 100% ON to about 17% OFF.This is accomplished by using a p-channel MOSFET, which is inherentlysafe.

MAX power rating is 115 watts. DO NOT EXCEED! 


P115W-A6 comes with a detachable daylight sensor, which simply plugs into the pathBlazer. The daylight sensor functions as a switch; it stops modulation when it cannot see enough daylight. Since the circuitry is conrolled by a microprocessor, it allows for customizable features.
Programmable Daylight Sensor

If you turn the high beam on and then turn the ignition on three times quickly, the sequence is interpreted as an active command to change the sensitivity. Software version v.823A allows 8 linear steps between the high and low end.

The daylight sensor has a low frequency filter to avoid false triggering. Please note that florescent lamps may not trigger the sensor - it needs constant incandescent light. 
pathBlazer uses a soft-switching technique. It throttles the current flow through the bulb filament, so that there's no "thermal shock" due to a sudden inrush of current, which can damage the bulb filament or shorten its life considerably. This is far superior than maintaining a small voltage! 
Select hi-beam to modulate - as long as there's sufficient daylight. If you enter a tunnel or if it gets dark, it will stop the modulation of the hi-beam and stay ON steady. Select lo-beam to end modulation. 

DIY logo

Installation does not require any special tools. Everything needed to complete the job is in the product package.

Follow the steps described here and refer to the Installation Manual enclosed in the product package.

Click here for Installation Manual

You may also be interested in the following product(s)








Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.