P115W-A6 is a plug-in version for BMWs with an AMP 6-pin connector of the headlight housing, which is accessible at the back of the housing. This is an EXTERNALLY mounted unit and does not fit inside the headlight assembly.
P115W-A6 is a plug-in unit for many BMW K-series and R-series models. It modulates hi-beam bulbs - one or two depending on the multiple bulb arrangement of headlights. This is heavy-duty version with dual MOSFETs.
■ For CAN-bus BMWs, choose "Z" version above.
The unit is 1.0"(25.4mm) by 1.35" (34.4mm), and externally mounted. The matching adapter for the AMP connector makes this a plug-n-play operation.
pathBlazer circuit modulates the hi-beam current - from 100% ON to about 17% OFF.This is accomplished by using a p-channel MOSFET, which is inherentlysafe.
MAX power rating is 115 watts. DO NOT EXCEED!
If you turn the high beam on and then turn the ignition on three times quickly, the sequence is interpreted as an active command to change the sensitivity. Software version v.823A allows 8 linear steps between the high and low end.
The daylight sensor has a low frequency filter to avoid false triggering. Please note that florescent lamps may not trigger the sensor - it needs constant incandescent light.
Installation does not require any special tools. Everything needed to complete the job is in the product package.
Follow the steps described here and refer to the Installation Manual enclosed in the product package.