P115W-H3-ZH4

Indian-front

2016 and newer Indian Cruiser, Touring and Scout models with LED headlamp

In stock
SKU P115W-H3-ZH4
$129.95

P115W-H3-ZH4

ZH4

P115W-H3-ZH4 is designed with the standard 3-pin H4 style plugs shown here. This unit is for LED headlamps of the 2015 and newer Indian Cruiser, Touring and Scout models.

Note! Some 2015 thru' 2017 models came with CANbus controller. Please choose appropriate option when ordering this item.

As shown here, you can access the 3pin plug of the LED headlight by removing the headlight nacelle. Simply take apart the 3-pin connection and plug the pathBlazer in between.

Indian-access

pathBlazer circuit modulates the hi-beam current - from 100% ON to about 17% OFF. This is accomplished by using a p-channel MOSFET, which is inherently safe. The MOSFET is designed to fail in the ON state. For additional safety, the circuits DO NOT utilize the lo-beam whatsoever!

This unit has a software version specifically for LED drive.

P115W-H3-ZH4 comes with a detachable daylight sensor, which simply plugs into the pathBlazer. The daylight sensor functions as a switch; it stops modulation when it cannot see enough daylight. Since the internal circuitry is controlled by a microprocessor, it allows for customization features.

ZH4-Install

3-Click Programming: If you turn the high beam on and then turn the ignition on three times quickly, the sequence is interpreted as an active command to change the sensitivity. Current software version v.3C-11 allows 8 linear steps between the high and low end.

The daylight sensor has a low frequency filter to avoid false triggering. Please note that florescent lamps may not trigger the sensor - it needs constant incandescent light.

pathBlazer uses a soft-switching technique. It throttles the current flow through the LED arrays of headlamps, so that appropriate intensities are maintained for modulation.

Select hi-beam to modulate - as long as there's sufficient daylight. If you enter a tunnel or if it gets dark, it will stop the modulation of the hi-beam and stay ON steady. Select lo-beam to end modulation.

DIY logo

Installation does not require any special tools. Everything needed to complete the job is in the product package.

Follow the steps described here and refer to the Installation Manual enclosed in the product package.

Installation videos with standard bulbs and LED bulbs are viewable on our YouTube channel. Or you can search for them directly on YouTube.

Click here for Installation Manual

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account