P115W-T6


Tenere front

2015 & Newer Yamaha Tenere

LED drive software is programmable on this modulator.

In stock
SKU P115W-T6
$129.95

P115W-T6

P115W-T6

P115W-T6 is designed with a 6-pin plug for the factory LED headlamp of the 2015 and newer Yamaha Super Tenere models. Simply take apart the stock 6-pin connection and plug the pathBlazer in between.

T6-ACCESS

As shown here the 6-pin plug is located slightly below and aft of the right turn signal. It is inside the large rubber boot.

pathBlazer circuit modulates the hi-beam current - from 100% ON to about 17% OFF. This is accomplished by using a p-channel MOSFET, which is inherently safe. The MOSFET is designed to fail in the ON state. For additional safety, the circuits DO NOT utilize the lo-beam whatsoever!

This is special unit which is trigger actuated. This unit has a software version specifically for LED drive.

Do not use with incandescent bulbs. 

P115W-T6 comes with a detachable daylight sensor, which simply plugs into the pathBlazer. The daylight sensor functions as a switch; it stops modulation when it cannot see enough daylight. Since the internal circuitry is controlled by a microprocessor, it allows for customization features.

Install 2018 GL1800

Programmable Daylight Sensor

3-Click Programming: If you turn the high beam on and then turn the ignition on three times quickly, the sequence is interpreted as an active command to change the sensitivity. Current software version v.3C-11 allows 8 linear steps between the high and low end.

The daylight sensor has a low frequency filter to avoid false triggering. Please note that florescent lamps may not trigger the sensor - it needs constant incandescent light.

pathBlazer uses a soft-switching technique. It throttles the current flow through the LED arrays of headlamps, so that appropriate intensities are maintained for modulation.

Select hi-beam to modulate - as long as there's sufficient daylight. If you enter a tunnel or if it gets dark, it will stop the modulation of the hi-beam and stay ON steady. Select lo-beam to end modulation.

DIY logo

Installation does not require any special tools. Everything needed to complete the job is in the product package.

Follow the steps described here and refer to the Installation Manual enclosed in the product package.

Installation videos with standard bulbs and LED bulbs are viewable on our YouTube channel. Or you can search for them directly on YouTube.

Click here for Installation Manual

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account

People Also viewed…